Clamp of the cable is loosened using the screw driver with flat head

Make sure that all these tools are ready before you start the work.The negative cable of the car's battery is unplugged first. Clamp of the cable is loosened using the screw driver with flat head. The cable is placed inside. Use your screw driver with flat head to pry the center clock from the car's dash board. There is a gap between the housing of the center clock and trim panel in which the screw driver will fit perfectly.The housing of the clock is pulled carefully using your hand and the power cable which is present on the back side of the car's center clock is unplugged. The clock is placed away for this moment. The rear side of the car's dash opening will have screws which are removed using the screw driver (Phillips).The bottom side of the car's dash panel will have two screws. Both are Wholesalers Film bolwing machine removed by the same screw driver. The panel that is present around the car's stereo is pulled carefully by your hand. The wiring to the weather controllers is removed. After you remove it, the panel is removed easily and it is placed away.You will find four screws on the edges of the radio set. These screws Screw & Barrel For Single Screw Extruder Suppliers are removed using appropriate screw driver. Use your both hands to pull the radio set out by giving equal forces on two sides. The radio set is pulled such a way that the back side of the radio is visible. Disconnect all the wires.Power cable and the antenna are pulled by your hand. You will find a binder to group all the plastic speaker wires. The binder itself is pulled carefully.Thus this article explains How to Remove the Stereo in a Honda Accord without much difficulty.

[ بازدید : 190 ] [ امتیاز : 3 ] [ نظر شما : ]